************** VERSION 4.16 ****************
This firmware upgrade is for use with the Spider 2

It is compatible with FSP-202 software

Extract the ".tar" firmware files from the zip file and copy them onto a laptop or PC connected to the Spider 2.

Log in to the unit then go to the About page and note your unit's current software version, e.g. "FSP-202 4.12".

Go into Change Setup and navigate to Upgrade Software.  Click the "Choose File" button and browse to then select the ".tar" file matching the current software version.
For example, if your unit is currently running "FSP-202 4.12" software and you are upgrading to 4.16, you would select the "FSP-202_spider_4.12-to-4.16_locked.tar" file.

Click Open then "Upgrade".  A warning will pop up asking whether you want to proceed.  Click "OK".
At this point the upgrade file is loading.  There is no need to exit the page or click anything.  When the file has loaded, the upgrade page will exit back to Change Setup and the upgrade will proceed in the background.  After a couple of minutes the LCD will display "Reloading" and the unit will boot with the new firmware.


*** CHANGE LOG ***
## 4.16 - 2025-11-25
### Fixed
System log fills if I/O board stops responding
System log entries may be lost when clock changes


## 4.15 - 2025-10-08
### Added
Option to hide passwords in user interface

### Changed
Increased SMTP username and password lengths to 80 chars

### Fixed
SMS fails to send if > 160 chars with SIMCom modem


## 4.14 - 2025-09-15
### Fixed
History downloads fail over slow (remote) connections
Modem does not register after power cut in low power mode
Control pulses do not finish in low power mode


## 4.13 - NOT RELEASED


## 4.12 - 2025-08-11
### Added
System recovery mechanism - emails an alarm message after system failure
Flash write failures trigger a system error/alarm
Modem IMEI displayed on About page
Serial number included in config file

### Changed
Software item code displayed on LCD instead of version hash
Updated branding
Remote session timeout increased to 10 minutes to match login timeout


## 4.11 - 2025-06-13
### Changed
Display year with four digits on LCD date/time page

### Fixed
Unable to send report if email subject is missing


## 4.10 - 2025-04014
### Added
RST ALx SMS command

### Fixed
Report time does not reset when period changes
Report generation stuck in fail loop


## 4.09 - 2025-02-13
### Added
Filesystem write failures trigger system alarms
CNALL SMS command to set state and pulse all controls

### Fixed
Device sleeps while waiting for login via GPRS
Failed reports do not clean up temp files


## 4.08 - 2024-09-11
### Added
Modem signal logging
System error alarms
Config file indicates device type

### Changed
Alarm email footer

### Fixed
Counters increment by 32768 when I/O board is power cycled
Two digit alarm number cannot be acknowledged by SMS
Input events do not wake device from off state
Alarm acknowledgement emails sent in low power mode when not enabled
Version information in config is automatically regenerated
EXITSETP logged at startup
NORML ST logged in Spider mode


## 4.07 - 2024-08-19
### Changed
Reduced system boot and application start time

### Fixed
Location not included in SMTP From: header
Name property missing from SMTP Content-Type: header
Controls can get out of sync when ram config is cleared
Result codes should not be logged in Spider mode


## 4.06 - 2024-07-22
### Added
Implement base Spider variant
NTP support
